HOW TO FLASH THE ZIDOO X1 II FIRMWARE
1 – First of all, Download available ZIDOO_X1 II images & Tools
- Download here: Zidoo X1 II Flash Image (V1.0.7). and uncompress the file for the image
- Zidoo X1 II Flashing Tool (v1.39) or http://forum.zidoo.tv/index.php?attachments/x1-iifactorytool_v1-41-rar.898/
- Or other driver here: Generic Driver – The driver works better in Windows 10.
2 – How to Flash using the Image file:
-
To flash a Zidoo X1 II, you are going to need an OTA cable. You can make your own by following this better instruction of these instructions or these instructions.
- Download both the Image and Flashing files. (NOTE: Use the Generic Driver, as it works better in Windows 10)
- Extract both files in (1) and (2) to a local directory. (I.E.: on your desktop create a directory zidoo and extract the files there)
-
Boot into Flashing Mode:
- Make sure the Zidoo X1II is powered down, all cables are removed and you have your USB OTG Cable is plugged into your PC.
- Use a pin and push it into the “RESET” hole AND HOLD IT THERE.
- Using the “double sided usb male cable” connect to your USB/OTA of the Zidoo X1II.
- Start your “Factory Tools” program and choose your extracted image file:
- connect to the flat usb port then you should switch on the power
- You will also see one of the ports display “LOADING” and unloose the reset button .
- Hit run and wait for the dump to complete.
- Boot the system up.