NOTE: Please remove all the external storage device（such as Sdcard、SATA、USB）on box before you flash it. Just keep the one USB your need for falshing.

There is some risk for flashing your UHD3000 BOX, please be quite careful to make it.(It will clean out user data entirely, if you are not professional, please be cautious to do it.)

The following Flashing Process is about UHD3000, attaching UHD3000 TV BOX:

First, do some preparation:

① A UHD3000 TV BOX, one HDMI cable, A TV set (You kept surely, do not say any more);

② a quite fine needle, you can use other finer tools instead of it, such as toothpick, etc. ( In order to hold down the Reset button );

③U disk, ensuring that it is as below the format of FAT32

At the beginning, you need to download the ROM and rename to "install.img";

Download address：

With Google framework version： https://mega.nz/file/eNE03ZSZ#qzDDCvu5okSNGk7_7E3EOKeQH7UPWxN3iLi4kz0EdeA

Without Google framework version：https://mega.nz/file/6FN0TTwR#9BwxgUcpw2VRRuIQhl8kzMhujSw2bimaorX6O9nPADQ

then copied to the Root Directory of the Udisk, then, insert U disk into one of USB3.0 port, as shown below red line mark.

Flash your box now: First,press the RESTORE button then turn on the power by the same time,

while you have connect to TV, the TV will show the schedule,proved that you are flashing now，if you have connect to TV,

the TV will show the schedule,proved that you are flashing now,(If not shown or have a green screen, is a normal phenomenon, don't power off either,just wait for 10 minute until the vfd shows "hello") 

this flash process about two minutes ) , after finishing flashing will showed you install completed,

then it will enter the system automatically(It will be a little longer for the first time, about 2 minutes),